/
/
/
/
INTELLIGENT ELECTRONIC TWIST-LOCK PHOTOELECTRIC

INTELLIGENT ELECTRONIC TWIST-LOCK PHOTOELECTRIC

The dimming photocontroller JL-241/242/243 series is applicable to control any independent LED home/street lighting automatically in accordance with the ambient natural lighting level.
Category : Photo Controller

JL-243C*1 - K*2 - IP65*3 - F*4 (100*5 - 05*6 - D40*7 - L40*8)

*:Model Number

**:Metal Armor

Null=Polycarbonate Enclosure with UV Stabilizer

K=Supplemental Painted Aluminum Armor

***:IP protection

IP65 =Complete Sealing with Silicone Gasket

IP67=Full Sealing with Silicone Gasket and Pin protection

****:Enclosure Color

A=Red;B=Orange;C=Yellow;D=Green;E=Brown;F=Blue;G=Violet

H=Black;I=Auburn;J=White;K=Gray;L=Maroon;W=Clear

*****:Constant On/Off Level

******:Turn Off Time Delay

*******:Midnight Dimming Level

********:Midnight Dimming Time

image/yC3HzshPTyqHcJplRjMiuA
Product Summary

The dimming photocontroller JL-241/242/243 series is applicable to control any independent LED home/street lighting automatically in accordance with the ambient natural lighting level.

This product is designed with microprocessor circuits with IR-filtered silicone sensor, a heavy duty surge arrester (MOV) is provided to protect the lamp from inrush current as well as impulse by lightening.

Further, a preset 10 seconds time-delay prevents excessive operation due to spotlight or lightning during the night time.

A heavy duty relay supports the work life of over 15,000 cycles, and offers extra long work life when an optional metal Armor is applied together.

This product provides twist lock terminals and signal contacts meeting the requirements of ANSI C136.41-2013, as well as being listed by UL under the Standard for Plug-In, Locking Type Photocontrols for Use with Area Lighting ANSI/UL773.


Installation

Disconnect power, remove junction box cover, place the SWITCH in knockout hole and fasten with locknut. 

Wire according to the diagram in right hand.

Do not install the switch with the Photocell facing artificial or reflected light. This will cause the unit to cycle on and off at night.


Initial Testing

It is normal for the SWITCH to take several minutes to turn off when first installed.

To test “turn on” during daytime, cover its eye with sliding the metal strip mounted.

Do not cover with finger because light traveling through fingers may be great enough to keep the switch open.

Test will take approximately 2 minutes.

 


Tel:+86-591-87533017, 88000103,
88000107, 88000113, 88000115

3/F NO. 91 Taiyu Rd, Fuwan Pian,
Jinshan Industrial zone, Fuzhou,PRC 350008

Follow us

Copyright © Bonle (Fuzhou) International Co., Ltd.  All Rights Reserved  Powered by www.300.cn  闽ICP备17032973号-1